Operation Manual

P14
SPECIFICATIONS
Symptom Cause Remedy
No picture The receiver can’t receive
the signal
Check the antenna cable,
replace the cable, or
connect the cable to the
receiver tightly.
Incorrect values of some
tuner parameters.
Set the values of the tuner
parameters correctly in the
installation menu.
Wrong direction of the dish Check the signal
strength with a spectrum
analyzer and adjust your
dish correctly.
Receiver tries to start-up,
switches ON/OFF/ON/
OFF… or displays “LOAD”
Receiver detected short
cut in your cable system or
detected “Antenna Power
Overload”.
Disconnect receiver from
main power
Check your cable system.
Remove short cut.
Replace LNB.
Restart receiver.
The remote control does
not work
The batteries of the remote
control are not inserted
or exhausted
Check whether the
batteries are inserted
correctly in your remote
control. Check the
batteries, and if exhausted
replace the batteries in the
remote control.
The USB storage device is
not recognized.
Wrong formatted Format USB device
by receiver in menu
“Recording Device”
The external USB HDD
does not start.
Power consumption is
too high.
Connect extra power
supply adaptor to your
USB HDD.
A.2 SPECIFICATIONS
Demodulator
Modulation: QPSK
Input Symbol Rate: 2~45 Ms/s
SCPC /& MCPC signals from C & KU and satellites
Video Decoder
Profile level: MPEG2 MP@ML
Input Rate: Max. 60 Mbits/s
Video Resolution: 720 x 576 pixels (PAL), 720 x 480 pixels (NTSC)
Aspect Ratio: 4:3, 16:9