Operation Manual

E-DOC-CTC-20080118-0051 v2.0
42
4 Getting the Most O
ut of Your Thomson Gat
eway
Activating services on the web pages
To activate/deactivate supplementary services via the web page:
1 Browse to the Thomson Gateway Web Interface.
2 On the Tools menu, click Content Sharing.
3 In the Navigation Bar, click Configure.
4 In the Pick a task list, click View Telephony Services.
5 In the Navigation Bar, click Configure.
6 To activate/ deactivate supplementary services select/clear the check box of the supplementary service.
7 Click Apply.
Call Forwarding
Call Forwarding informs you about the call forwarding parameters:
 CFNR-timer or Call Forwarding on No Reply timer is the time expressed in seconds after which an
incoming call is forwarded when not answered.
 CFNR-destination or Call Forwarding on No Reply destination is the telephone number to which a call is
forwarded to when the CFNR-timer expires.
 CFU-destination or Call Forwarding Unconditional is the telephone number to which an incoming call is
always forwarded to.
 CFBS-destination or Call Forwarding on Busy Subscriber is the telephone number to which an incoming
call is forwarded to when your telephone is busy.
Using switching order commands
In order to use switching order commands (R or hook flash followed by a digit), certain supplementary
services have to be activated.
The following list gives an overview of the supplementary services that have to be activated in order to use
switching order commands (SOC):
 Activate Hold when you want to
Action Press Illustration
To put an active call on hold and enable a
call set up (the dial tone is generated)
R, 2
To terminate the call on hold R, 0
To terminate an active call and switch to
the call on hold
R, 1
CB
A
on hold
dial tone
CB
A
active
A presses
R2
CB
A
active
CB
A
active
on hold
A presses
R0
CB
A
active
CB
A
active
on hold
A presses
R1