Operation Manual

E-DOC-CTC-20080118-0051 v2.0
41
4 Getting the Most Out of Your Thomson Gateway
4.2.2 Telephony services
Introduction
Telephony services or supplementary services add extra functionality to your phone. Which supplementary
services that are available is determined by your service provider.
To following list gives an overview of the services that may be available:
 3pty: three party call
 Callreturn: to call back the last missed call
 Ccbs: call completion on busy subscriber (automatic callback)
 Cfbs: call forwarding on busy
 Cfnr: call forwarding on no reply
 Cfu: call forwarding unconditional
 Clip: calling line identification presentation
 Clir: calling line identification restriction
 Clironcall: clir for only one call
 ForcedFXO: switch to FXO (PSTN)
 Hold: put an active call on hold
 Mwi: message waiting indication
 Transfer: call transfer between local ports
 Waiting: incoming call while active call indication
 Waitingoncall: call waiting active for only one call.
Checking which services that you can use?
To check which services you can use:
1 Browse to the Thomson Gateway Web Interface.
2 On the Tools menu, click Content Sharing.
3 In the Navigation Bar, click Configure.
4 In the Pick a task list, click View Telephony Services.
5 Under Telephony Services, you can see the services that are supported by your provider.
Activating services
You can activate/deactivate supplementary services in two ways:
 Via activation/deactivation codes, also referred to as service code commands.
 Via the Telephony Configure page.
The activation/deactivation codes for a specific supplementary service is displayed in the overview.
For example, to activate Call Hold dial *94, to deactivate the service dial #94.