Operation Manual

E-DOC-CTC-20080118-0051 v2.0
25
3 Adding New Devices to your Network
3.2.2 Configuring your Thomson Gateway
Introduction
If you configured your Thomson Gateway using the Guided Installation, the telephony service will already be
configured by the Setup wizard.
If you choose to configure your Thomson Gateway manually or you still need to configure the telephony
service, you can follow the procedure below.
Procedure
Proceed as follows:
1 Enable the Telephony Service
2 Assign Phone Numbers
3 Configure the Telephony Service
Enable the Telephony Service
To enable the telephony service:
1 Browse to the Thomson Gateway Web Interface.
2 On the Toolbox menu, click Telephony.
3 In the Navigation Bar, click Configure.
4 Select Service Enabled.
5 Click Apply.
Assign Phone Numbers
To configure your Internet SIP telephone numbers:
1 Browse to the Thomson Gateway Web Interface.
2 On the Toolbox menu, click Telephony.
3 In the Navigation Bar, click Configure. Assign phone numbers to the ports. If you want to use the same
number for all ports, select Port ‘All’.
4 Click Apply.
Configure the Telephony Service
Proceed as follows to configure the telephony service:
1 Browse to the Thomson Gateway Web Interface.
2 On the Toolbox menu, click Telephony.
3 In the Navigation Bar, click Expert configure.
Your Internet connection must be up and running before you can configure Internet telephony.
The phone numbers are provided by your provider.