Operation Manual

19
 This function can only be used with Intensive, Normal, ECO, Glass and 90 minutes
programmes.
 When this function is activated, the dishwasher will increase temperature at the end
of a washing programme to improve drying.
11. Repeatedly press to select the upper, lower or both baskets to be sprayed
during a washing cycle.
 The corresponding indicator light (s) will illuminate.
12. Start the washing programme by pressing .
13. At the end of the washing programme, the dishwasher will buzz and automatically
stop.
14. Wait for about 15 minutes before you open the dishwasher door in order to avoid
burns.
15. Unload the dishes.
The washing cycle will not start if the dishwasher door is left open or not properly
closed.
Do not open the door when the dishwasher is working since hot water may be
ejected, which could cause scalding.
Adding extra crockery
1. Without switching off the machine, press to pause.
2. Open the door, taking care to avoid the escaping steam.
3. Place the crockery inside the dishwasher.
4. Close the door and press . The cycle will start from the point at which it was
interrupted.
Modifying a washing programme in progress
If a mistake was made during the washing programme selection process it is possible to
change the programme.
1. Press to pause.
2. Press and hold P for about 3 seconds. You will hear a beep.
3. Repeatedly press P to select a new programme.
 The new programme indicator light will illuminate.
4. Press to start the programme.
Child lock function
This function allows you to lock the buttons on the control panel. Children will not be able
Downloaded from www.vandenborre.be