Operation Manual

18
NOTE:
1. The washing time may vary according to the incoming water temperature and the
environmental temperature.
2. The power consumption in left-on mode is 0.49W (door open), in off-mode it is 0.45W.
Starting the Dishwasher
1. Turn the water tap on.
2. Open the dishwasher door.
3. Check the filters.
 Ensure they are clean and properly positioned. See “Cleaning and maintenance”
section.
4. Check that there is rinse aid and salt.
5. Load the dishes.
 Ensure that the spray arms can rotate freely.
6. Add the required amount of detergent into the dispenser according to the “Washing
Programmes” chart.
7. Close the dishwasher door securely.
8. Press to switch on the dishwasher.
 The ECO programme indicator light will illuminate and the display will show the
washing time.
9. Select the desired washing programme by repeatedly pressing P.
 The corresponding washing programme indicator light will illuminate.
 Delay timer: The delay timer allows you to delay the start of a washing programme
from 1 hour to a maximum of 24 hours.
Repeatedly press until the desired start delay time is shown on the display, e.g.
H:03 for a 3-hour delay.
Once the delay timer has been set, press to activate the function.
To cancel the delayed start, first press then repeatedly press until the
display shows “H:00”.
10. If you want to activate extra drying function, press and the corresponding
indicator light will illuminate.
Downloaded from www.vandenborre.be