Operation Manual

100
E-DOC-CTC-20050429-0103 v2.0
Chapter 5
Software Upgrade
5.1 Upgrade Wizard on Setup CD
Introduction The procedures described in this section are valid only in case:
 You run an MS Windows Operating System or Mac OS X.
 Your SpeedTouch™ and computer are properly connected through Ethernet.
During the upgrade procedure in most cases configuration settings are backed up by
the wizard and restored after uploading the system software.
Starting the Upgrade
Wizard
To launch the SpeedTouch™ Upgrade Wizard:
1 Insert the Setup CD in your computer’s CD-ROM or DVD-ROM drive. The
SpeedTouch™ CD menu will pop up automatically.
2 In the SpeedTouch™ CD Menu, click SpeedTouch Maintenance.
3 Click Upgrade My SpeedTouch, to start the SpeedTouch™ Upgrade Wizard.
4 See “ Upgrade procedure” on page 101 to continue.
!
It is NOT possible to upgrade your SpeedTouch™ over a wireless
connection.
If not:
 In MS Windows:
Click Run on the Start menu and enter the following path:
D:\Setup.exe where D stands for the drive letter of your CD-ROM
or DVD-ROM drive.
 On Mac OS X
Double-click the CD icon and then double-click Menu.