Operation Manual

GENERAL INFORMATION
Power supply
• Remove the battery compartment (6) cover by sliding it downwards.
• Insert Two batteries (1.5V, AAA, R03 or UM4), taking care to respect the polarity
indicated.
• Put the cover (6) back in place.
Radio reception
1 Push the switch to FM/ MW control to power on the set.
2 Set the band selector to FM or MW.
3 Select your station using the TUNING control.
4 Press the VOL+ or VOL – to control the volume level.
5 Push the switch to OFF control to power off the set.
Connecting headphones
• You can connect headphones to the headphone socket.
The loudspeakers will then be switched off.
Problem
- Possible cause
• Remedy
No sound / power
- VOL – adjusted to the min.
• Adjust the VOL+.
- Batteries dead / incorrectly inserted
• Insert (fresh)batteries correctly
- Headphones connected to the set
• Disconnect headphones.
Poor radio reception
- Weak radio signal
• For FM, extend, incline and turn the telescopic antenna for best reception.
Reduce its length if the signal is too strong.
• For MW,the set uses a built-in antenna. Direct this antenna for best reception by turning
the whole set.
ENVIRONMENTAL INFORMATION
This appliance bears the WEEE mark (Waste of Electric and Electronic
Equipment) signifying that, at the end of its life cycle, it should not be disposed
of with household waste, but at a recycling centre. The recycling of waste
contributes to the conservation of our environment.