User's Manual

02 03
5. Panel introduction
Remote-control unit
6. Operation instructions
Introduction to buttons and hole sites: A total of 8 buttons and hole sites which are
defined as follows:
Note: Press button 13 "Volume mode switch" to switch among three modes, i.e.
tE/bA/UO. It can be used in conjunction with “Volume +/-” key to adjust the volume
size. It is defaulted as UO.
Turn on the microphone switch in any mode to activate the Karaoke function.
Karaoke function
This machine theoretically supports all mobile phones with Bluetooth function and any
related devices to connect Bluetooth and play music.
7. Equipment compatibility
1. /M: Long press to start up/shut down; short press to switch mode;
2. : Short press to play or suspend music.
3. : Long press to reduce the volume; short press to shift to the previous song.
4. : Long press to increase the volume; short press to shift to the next song.
5. OUT: Audio output 6. U6. USB: USB play
7. DC IN: Type C 5V/2A charging 8. AUX: Audio input (built-in reset button)
1. Power off
2. Microphone volume +
3. Volume +
4. Previous song
5. Bluetooth disconnected
/loopback connection
6. Microphone reverberation +
7. Mute
8. Microphone volume -
9. Play / suspend
10. Next song
11. Volume-
12. Sound
13. Menu
/ Volume mode switch
14. Microphone reverberation -
15. Reset
16. Mode switch
1.Short press /M key to switch to Bluetooth mode, which will enter the default
Bluetooth mode and wait for pairing.
2.Turn on the Bluetooth function on the device, and the device will start searching the
Bluetooth device.
3.Select "K600" from the list of found devices.
4.Enter the password "0000" as requested and press OK.
5.After successful pairing with the device, the indicator light will be constantly on.
Note: Bluetooth playback is controlled by the buttons on your device and
the remote control.
Bluetooth mode
After start up, use a 3.5mm audio cable to connect other audio devices to the "OUT"
jack of the speaker, and then short press the speaker " /M " button or the "MODE"
button on the remote-control unit to switch to the audio output mode. At this time, the
sound is played from the speaker as an audio source.
Coaxial output mode
Audio input mode
After start up, use a 3.5mm audio cable to connect external audio sources to the "AUX"
jack of the speaker, and then short press the speaker “ /M" button or the "MODE"
button on the remote-control unit to switch to the audio input mode. After that, you can
play music from an external audio source such as MP3/CD (please adjust the volume
of the external audio source to moderate and play).
1
2
3
4
5
6
7
8
1.In any play state, insert the U disk stored with MP3 songs into the USB interface. The
speaker will automatically identify and skip to the U disk play mode. The songs will be
played in copy order.
2.Short press “ " button to play and suspend music.
3.Short press to switch to the next song; long press to increase the volume.
4.Short press to switch to the previous song; long press to decrease the volume.
U disk play mode