User's Manual

• Lift the battery pack and connect it's plug to the jack inside

the com partment.

NOTE: It is important to maintain the polarity (black and red wires) to th e

jack in side the compartmen t as shown in the illustration .

• Slide the battery com partment cover back into place.

NOTE: If the handset battery is not installed or the battery pack is not

properly conn ected inside the battery compartment, th e h andset displays “NO

BATTERY” when the handset is placed in th e base cradle.

4. Connect the telephone line cord by plugging one end of the telephone

line cord into the jack on the back of the base m arked TEL LINE and

other end into a telephone wall jack.

NOTE: On e base can support up to four handsets.

5. If you purchased m odel 25825, place the handset in the base cradle.

The charge indicator turns on to indicate the battery is charging.

If you purchased model 25826GE, place one handset in the base cradle,

then plug the charging cradle into an electrical outlet, and place the

other handset in the cradle. The charge indicators turn on to indicate

the battery is charging.

If you purchased model 25826GC, place one handset in the base cradle,

then plug both charging cradles into an electrical outlet, and place a

handset in each cradle. The charge indicators turn on to indicate the

battery is charging.

6. Allow the handset(s) to charge on a flat surface, such as a desk or table

top, for 16 hours prior to first use. If you don't properly charge the

phone, battery performance is com prom ised.

BLACK WIRE

RED WIRE

BATTERY

PRESS DOWN

FIRMLY