Operation Manual

60
Bridge Commands
E-DOC-CTC-20040210-0030 v1.0
bridge iflist
Show the current state of all or the selected bridge interfaces.
SYNTAX:
where:
EXAMPLE:
Note In case of a SpeedTouch™530 device: NEVER change or delete the usb_bridge interface!
bridge iflist [intf = <intfname>]
intf The name of the bridge interface for which the configuration must be
shown.
Browse through the available entries via the ARROW UP and
ARROW DOWN keys.
If no interface is specified, all bridge interfaces are shown.
OPTIONAL
=>bridge iflist
OBC : Internal
Connection State: connected
Port: OBC PortNr: 0 PortState: forwarding
RX bytes: 75783 frames: 572
TX bytes: 82843610 frames: 341554 dropframes: 0
ethport1 : Internal
Connection State: connected
Port: ethport1 PortNr: 1 PortState: forwarding
RX bytes: 156472129 frames: 5903256
TX bytes: 75689 frames: 425 dropframes: 5561702
usb_bridge : dest : usb_port
Retry : 10 QoS : default Encaps : llc/snap Fcs : off
Connection State: connected
Port: wan2 PortNr: 4 PortState: forwarding
RX bytes: 0 frames: 0
TX bytes: 0 frames: 0 dropframes: 0
TestBridge: dest : TestBridge
Retry : 10 QoS : default Encaps : llc/snap Fcs : off
Connection State: connected
Port: wan0 PortNr: 5 PortState: forwarding
RX bytes: 83 frames: 13
TX bytes: 30740 frames: 341554 dropframes: 0
=>