Operation Manual

59
Bridge Commands
E-DOC-CTC-20040210-0030 v1.0
bridge ifdetach
Detach (i.e. disconnect) a bridge interface.
SYNTAX:
where:
EXAMPLE:
Note In case of a SpeedTouch™530 device: NEVER change or delete the usb_bridge interface!
RELATED COMMANDS:
bridge ifdetach intf = <intfname>
intf The name of the bridge interface to be detached.
Browse through the available entries via the ARROW UP and
ARROW DOWN keys.
REQUIRED
=>bridge iflist intf=TestBridge
TestBridge: dest : TestBridge
Retry : 10 QoS : default Encaps : llc/snap Fcs : off
Connection State: connected
Port: wan0 PortNr: 5 PortState: forwarding
RX bytes: 0 frames: 0
TX bytes: 0 frames: 0 dropframes: 0
=>bridge ifdetach intf=TestBridge
=>bridge iflist intf=TestBridge
TestBridge: dest : TestBridge
Retry : 10 QoS : default Encaps : llc/snap Fcs : off
Connection State: not-connected
Port: (Unassigned) PortNr: (Unknown) PortState: forwarding
=>
bridge ifadd Create a bridged Ethernet interface.
bridge ifattach Attach a bridge interface.
bridge ifconfig Configure a bridge interface.
bridge ifdelete Delete a bridge interface.
bridge iflist Show current bridge configuration.