Operation Manual

56
Bridge Commands
E-DOC-CTC-20040210-0030 v1.0
bridge ifconfig
Configure a bridge interface.
SYNTAX:
where:
Note In case of a SpeedTouch™530 device: NEVER change or delete the usb_bridge interface!
bridge ifconfig intf = <intfname>
[dest = <string>]
[qos = <string>]
[encaps = <{llc/snap|vcmux}>]
[fcs = <{off|on}>]
[portstate = <{disabled|learning|forwarding}>]
[retry = <number {0-65535}>]
intf The name of the bridge interface to configure. REQUIRED
dest The destination for this interface. Typically a phonebook entry.
This parameter only needs to be specified when an interface has
been created without specified destination.
OPTIONAL
qos The name of the Quality Of Service (QoS) book entry to apply on
this bridge interface.
OPTIONAL
encaps The type of encapsulation to be used for this bridge interface.
Choose between:
• llc/snap
• vcmux.
OPTIONAL
fcs Whether or not to include the Ethernet FCS in the packet header on
the WAN side. Choose between:
• off
• on.
The default is off.
Note FCS is normally left off.
OPTIONAL
portstate The bridge portstate for this interface.
Choose between:
• disabled
• learning
• forwarding.
OPTIONAL
retry A number between 0 and 65535.
Represents the number of times the SpeedTouch™ retries to set up
a WAN connection before giving up.
The default is 10.
OPTIONAL