Operation Manual

54
Bridge Commands
E-DOC-CTC-20040210-0030 v1.0
bridge ifattach
Attach (i.e. connect) a bridged Ethernet interface.
SYNTAX:
where:
EXAMPLE:
bridge ifattach intf = <intfname>
intf The name of the interface to attach.
Browse through the available entries via the ARROW UP and
ARROW DOWN keys.
REQUIRED
=>bridge iflist
OBC : Internal
Connection State: connected
Port: OBC PortNr: 0 PortState: forwarding
RX bytes: 75783 frames: 572
TX bytes: 82843610 frames: 341554 dropframes: 0
ethport1 : Internal
Connection State: connected
Port: ethport1 PortNr: 1 PortState: forwarding
RX bytes: 156472129 frames: 5903256
TX bytes: 75689 frames: 425 dropframes: 5561702
usb_bridge : dest : usb_port
Retry : 10 QoS : default Encaps : llc/snap Fcs : off
Connection State: connected
Port: wan2 PortNr: 4 PortState: forwarding
RX bytes: 0 frames: 0
TX bytes: 0 frames: 0 dropframes: 0
TestBridge: dest : (none)
Retry : 10 QoS : default Encaps : llc/snap Fcs : off
Connection State: not-connected
Port: (Unassigned) PortNr: (Unknown) PortState: forwarding
=>bridge ifattach intf=TestBridge
=>bridge iflist
OBC : Internal
Connection State: connected Port: OBC PortState: forwarding
...
TestBridge: dest : TestBridge
Retry : 10 QoS : default Encaps : llc/snap Fcs : off
Connection State: connected
Port: wan0 PortNr: 5 PortState: forwarding
RX bytes: 0 frames: 0
TX bytes: 0 frames: 0 dropframes: 0
=>