Operation Manual

46
AutoPVC Commands
E-DOC-CTC-20040210-0030 v1.0
autopvc config
Configure autopvc.
SYNTAX:
where:
autopvc config [mode = <{pseudo|passive|active}>]
[type = <{bridge|pppoerelay}>]
[opmode = <{partial|full}>]
[overwrite = <{disabled|enabled}>]
[peakrate = <number{0-27786}>]
mode Select the autopvc mode:
• pseudo:
enable only pseudo-ILMI (VP/VC 15/16). When connection
parameters are written to the MIB, display this information on
CLI or web-interface but do not use these parameters for
configuration.
• passive:
enable both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/VC 15/
16). When connection parameters are written to the MIB,
display this information on CLI or web-interface but do not use
these parameters for configuration.
• active:
enable both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/VC 15/
16). When connection parameters are written to the MIB, use
these parameters to configure phonebook entries, qosbook
profiles and bind bridge or PPPoE interfaces on top.
The default is passive.
OPTIONAL
type Type of autopvc:
• bridge
• pppoerelay:
an ETHoA interface will be created, will be bound to the ILMI
PVC and will be added to the PPPoE relay as relay port.
The default is bridge.
OPTIONAL
opmode Operational autopvc mode:
• partial: only read the ILMI VPC and VCC MIB tables
• full: read all supported MIB tables.
The default is partial.
OPTIONAL
overwrite Enable/disable UBR peak rate overwrite. OPTIONAL
peakrate A number between 0 and 27786.
Represents the UBR peak rate (in kilobits per second).
Note 0 indicates the linerate.
OPTIONAL