Operation Manual

40
ATM Commands
E-DOC-CTC-20040210-0030 v1.0
atm oam ccsend
Send CC activate/deactivate to connection.
SYNTAX:
where:
RELATED COMMANDS:
atm oam ccsend port = <{dsl0|dsl1|atm2|atm3|aal5|atm5} or number>
vpi = <number{0-15}>
[vci = <number{0-511}>]
[span = <{segment|end2end}>]
[action = <{activate|deactivate}>]
[direction = <{source|sink|both}>]
port The ATM port number.
Choose between:
• DSL0
• DSL1
• ATM2
• ATM3
• AAL5
• ATM5.
Or specify a port number (dsl0 has port number 0, ..., atm5 has port
number 5).
REQUIRED
vpi A number between 0 and 15.
Represents the Virtual Path Identifier (VPI).
REQUIRED
vci A number between 0 and 511.
Represents the Virtual Channel identifier (VCI).
For a VP cross-connection, use VCI=0 or do not specify.
OPTIONAL
span End2end or segment continuity check. OPTIONAL
action Enable or disable CC.
The default is disabled.
OPTIONAL
direction Indicates the direction of CC activity. Select either:
• source
• sink
• both.
If not specified, CC is activated/deactivated for both directions.
OPTIONAL
atm oam ccconfig Configure CC on the connection.
atm oam cclist Show current CCconfiguration.