Operation Manual

388
UPnP Commands
E-DOC-CTC-20040210-0030 v1.0
upnp config
Configure UPnP™ parameter(s).
SYNTAX:
where:
upnp config [maxage = <number{60-999999}>]
[defcservice = <string>]
[writemode = <{full|natonly|readonly}>]
[safenat = <{disabled|enabled}>]
[preferredaddress = <ip-address>]
maxage This parameter allows to configure how often the SpeedTouch™
sends a notification message to advertise its presence as an Internet
Gateway Device IGD) on the network.
Setting this parameter to a low value will increase the number of
packets sent over time on the network, but will make the state of
the device more up to date.
The default is 1800.
OPTIONAL
defcservice This parameter allows to configure the connection service to be
used by the DrSpeedTouch™ application during the troubleshooting
process (only when several connection services are configured on
the SpeedTouch™, else only the default connection service).
OPTIONAL
writemode Choose the set of rules to limit remote access from UPnP.
Choose between:
• full: the host will accept all the UPnP SET and GET actions.
• natonly: GET and NAT related SET actions will be accepted, all
other actions will be ignored.
• readonly: the UPnP control point will only be able to retrieve
information, all the SET actions are ignored.
OPTIONAL
safenat Enable / disable check on safe NAT entries.
If this check is enabled, all NAT create/delete requests for a LAN
side IP address different from the source IP address of the UPnP
message will be discarded.
OPTIONAL
preferredaddress Preferred ip address for UPnP advertisements (enter 0.0.0.0 for
none).
OPTIONAL