Operation Manual

383
Systemlog Commands
E-DOC-CTC-20040210-0030 v1.0
systemlog send
Send syslog messages from the internal SpeedTouch™ Syslog message buffer to a specified local or remote syslog
server host.
SYNTAX:
where:
Note There will be no notification on whether the host has received the messages or not.
systemlog send [fac = <supported facility name>]
[sev = <supported severity name>]
[hist = <{no|yes}>]
dest = <ip-address>
fac Specify the facility name of the syslog messages to show.
Use one of the supported facility names (See “ Supported Syslog
Facilities” on page 416 for a listing of syslog facility names supported
by the SpeedTouch™).
If not specified, the messages of all the facilities will be shown.
OPTIONAL
sev Specify the lowest priority severity of the syslog messages to show.
Specifying a severity actually means specifying to show the syslog
messages with a severity as specified, and all messages with a higher
severity.
Use one of the supported severity names (See “ Supported Syslog
Severities” on page 417 for a listing of syslog facility names
supported by the SpeedTouch™).
OPTIONAL
hist The show messages over several SpeedTouch™ reboots (yes) or
show only messages since latest startup (no).
OPTIONAL
dest The IP address of the remote host on the local or remote network,
i.e. the collector's IP address, to send the syslog messages to.
REQUIRED