Operation Manual

381
Systemlog Commands
E-DOC-CTC-20040210-0030 v1.0
systemlog show
Show syslog messages in the internal SpeedTouch™ Syslog message buffer.
SYNTAX:
where:
systemlog show [fac = <supported facility name>]
[sev = <supported severity name>]
[hist = <{no|yes}>]
fac Optionally, Specify the facility name of the syslog messages to show.
Use one of the supported facility names (See “ Supported Syslog
Facilities” on page 416 for a listing of syslog facility names supported
by the SpeedTouch™).
If not specified, the messages of all the facilities will be shown.
OPTIONAL
sev Specify the lowest priority severity of the syslog messages to show.
Specifying a severity actually means specifying to show the syslog
messages with a severity as specified, and all messages with a higher
severity.
Use one of the supported severity names (See “ Supported Syslog
Severities” on page 417 for a listing of syslog facility names
supported by the SpeedTouch™).
If not specified, the messages of all the facilities will be shown.
OPTIONAL
hist Show messages over several SpeedTouch™ reboots (yes) or show
only messages since latest startup (no).
If not specified, only the recent messages will be shown.
OPTIONAL