Operation Manual

369
Switch Commands
E-DOC-CTC-20040210-0030 v1.0
switch mirror ingress
Enable or disable the specified port to be the Mirror Ingress Port.
Note Only one port can be the Mirror Ingress Port at any one time.
But a port can be the Mirror Egress Port and the Mirror Ingress Port at the same time.
SYNTAX:
where:
EXAMPLE:
Here port 2 is enabled as Mirror Ingress Port
Here port 2 is disabled as Mirror Ingress Port
RELATED COMMANDS:
switch mirror ingress port = <number{1-4}>
[state = <{enabled|disabled}>]
port The port to be the Mirror Ingress Port.
If no port number is specified, then the port number of the current
Mirror Ingress Port is shown.
REQUIRED
state This parameter permits to enable/disable a port as Mirror Ingress
Port.
OPTIONAL
=>switch mirror ingress port=2
=>switch mirror ingress
Ingress mirror port = 2
=>switch mirror ingress
Ingress mirror port = 2
=>switch mirror ingress port=2 state=disabled
=>switch mirror ingress
=>
switch mirror capture Define the specified port to be the Mirror Capture Port.
switch mirror egress Enable or disable the specified port to be a Transmitted Port Mirroring.