Operation Manual

368
Switch Commands
E-DOC-CTC-20040210-0030 v1.0
switch mirror egress
Enable or disable the specified port to be the Mirror Egress Port.
Note Only one port can be the Mirror Egress Port at any one time.
But a port can be the Mirror Egress Port and the Mirror Ingress Port at the same time.
SYNTAX:
where:
EXAMPLE:
Here port 1 is enabled as Mirror Egress Port
Here port 1 is disabled as Mirror Egress Port
RELATED COMMANDS:
switch mirror egress port = <number{1-4}>
[state = <{enabled|disabled}>]
port The port to be the Mirror Egress Port.
If no port number is specified, then the port number of the current
Mirror Egress Port is shown.
REQUIRED
state This parameter permits to enable/disable a port as Mirror Egress
Port.
OPTIONAL
=>switch mirror egress port=1
=>switch mirror egress
Egress mirror port = 1
=>switch mirror egress
Egress mirror port = 1
=>switch mirror egress port=1 state=disabled
=>switch mirror egress
=>
switch mirror capture Define the specified port to be the Mirror Capture Port.
switch mirror ingress Enable or disable the specified port to be a Received Port Mirroring.