Operation Manual

34
ADSL Commands
E-DOC-CTC-20040210-0030 v1.0
adsl config
Show/set the Asymmetric Digital Subscriber Line (ADSL) configuration.
Although the command is the same for both SpeedTouch™ ADSL/POTS and SpeedTouch™ ADSL/ISDN variants, the
command features specific parameter values per variant:
SYNTAX FOR ADSL/Plain Old Telephone Service (POTS) variants:
where:
SYNTAX FOR ADSL/Integrated Services Digital Network (ISDN) variants:
where:
Note If the command adsl config is executed and no parameters are specified, then the current ADSL
configuration is shown.
adsl config [opermode = <{ansi|g.dmt_annex_a|g.lite|multimode}>]
[maxbitspertoneUS = <number{10-14}>][trace = <{off|on}>]
opermode The operational mode of the SpeedTouch™ modem.
Choose between:
• ansi
• g.dmt_annex_a
• g.lite
• multimode.
The default is multimode.
OPTIONAL
maxbitspertoneUS A number between 10 and 14 (bits per tone).
Represents the maximum number of bits which can be allocated to
each ADSL DMT tone in the upstream direction.
The default is 13.
OPTIONAL
trace Enable/disable adsl tracing. OPTIONAL
adsl config [opermode = <{etsi|g.dmt_annex_b|multimode}>]
[maxbitspertoneUS = <number{10-14}>][trace = <{off|on}>]
opermode The operational mode of the SpeedTouch™ modem.
Choose between:
• ansi
• g.dmt_annex_b
• multimode.
The default is multimode.
OPTIONAL
maxbitspertoneUS A number between 10 and 14 (bits per tone).
Represents the maximum number of bits which can be allocated to
each ADSL DMT tone in the upstream direction.
The default is 13.
OPTIONAL
trace Enable/disable adsl tracing. OPTIONAL