Operation Manual

324
PPPoE Commands
E-DOC-CTC-20040210-0030 v1.0
pppoe rtdelete
Delete the route specification for a PPPoE link.
Note Use the command pppoe ifdetach for this interface prior to deleting route configurations.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
pppoe rtdelete intf = <intfname>
intf The PPPoE interface name for which to delete the route settings. REQUIRED
=>pppoe iflist
PPPoE1: dest : PVC3
Retry: 10 QoS default encaps LLC
mode = IP Routing
flags = echo magic accomp restart mru addr route savepwd PPPoE
trans addr = pat mru = 1492
route = 10.0.0.2/24 - 172.16.0.5/24 (metric 1)
user name = guest password = ********
admin state = down oper state = down link state = not-connected
LCP : state = initial retransm = 10 term. reason =
IPCP: state = initial retransm = 0 term. reason =
=>pppoe rtdelete intf=PPPoE1
=>pppoe iflist
PPPoE1: dest : PVC3
Retry: 10 QoS default encaps LLC
mode = IP Routing
flags = echo magic accomp restart mru addr route savepwd PPPoE
trans addr = pat mru = 1492
user name = guest password = ********
admin state = down oper state = down link state = not-connected
LCP : state = initial retransm = 10 term. reason =
IPCP: state = initial retransm = 0 term. reason =
=>
pppoe rtadd Configure a route specification for an upcoming PPPoE link.