Operation Manual

321
PPPoE Commands
E-DOC-CTC-20040210-0030 v1.0
pppoe ifscan
Scan a PPPoE interface for available Access Concentrator names and Service Names.
Note Use the command pppoe ifdetach for this interface before performing a scan on it.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
pppoe ifscan intf = <intfname>
[time = <number{0-36000}>]
intf The name of the Routed PPPoE interface to be scanned. REQUIRED
time A number between 0 and 36000 (seconds).
Represents the time to scan for services.
OPTIONAL
=>pppoe iflist
PPPoE1: dest : PPPoE1
Retry: 10 QoS default encaps VC-MUX
mode = IP Routing
flags = echo magic accomp restart mru addr route savepwd PPPoEOA
trans addr = pat mru = 1492
route = 0.0.0.0/0 - 0.0.0.0/0 (metric 0)
user name = guest password = ********
admin state = down oper state = down link state = not-connected
LCP: state = initial retransm = 10 term. reason =
IPCP: state = initial retransm = 0 term. reason =
=>pppoe ifscan intf=PPPoE1 time=45
Service Name Access Concentrator
Done !
=>
pppoe ifconfig Configure a PPPoE interface.