Operation Manual

320
PPPoE Commands
E-DOC-CTC-20040210-0030 v1.0
pppoe iflist
Show current configuration of all or a specified PPPoE interface(s).
SYNTAX:
where:
EXAMPLE INPUT/OUTPUT :
RELATED COMMANDS:
pppoe iflist [intf = <intfname>]
intf The name of the PPPoE interface.
If this parameter is not specified, all PPPoE interfaces are shown.
OPTIONAL
=>pppoe iflist
PPPoE1: dest : PPPoE1
Retry: 10 QoS default encaps VC-MUX
mode = IP Routing
flags = echo magic accomp restart mru addr route savepwd PPPoEOA
trans addr = pat mru = 1500
route = 0.0.0.0/0 - 0.0.0.0/0 (metric 0)
user name = guest password = ********
admin state = down oper state = down link state = not-connected
LCP: state = initial retransm = 10 term. reason =
IPCP: state = initial retransm = 0 term. reason =
PPPoE2: dest : PVC2
Retry: 10 QoS default encaps VC-MUX
mode = IP Routing
flags = echo magic accomp restart mru addr savepwd PPPoEOA
mru = 1500
user name = password =
admin state = down oper state = down link state = not-connected
LCP: state = initial retransm = 10 term. reason =
IPCP: state = initial retransm = 0 term. reason =
=>
pppoe ifadd Create a new PPPoE interface.
pppoe ifattach Attach a PPPoE interface.
pppoe ifconfig Configure a PPPoE interface.
pppoe ifdelete Delete a PPPoE interface.
pppoe ifdetach Detach a PPPoE interface.