Operation Manual

319
PPPoE Commands
E-DOC-CTC-20040210-0030 v1.0
pppoe ifdetach
Detach a PPPoE interface.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
pppoe ifdetach intf = <intfname>
intf The name of the PPPoE interface. REQUIRED
=>pppoe iflist
PPPoE1: dest : PPPoE1
Retry: 10 QoS default encaps VC-MUX
mode = IP Routing
flags = echo magic accomp restart mru addr route savepwd PPPoEOA
trans addr = pat mru = 1492
route = 0.0.0.0/0 - 0.0.0.0/0 (metric 0)
user name = guest password = ********
admin state = up oper state = up link state = connected
LCP: state = initial retransm = 0 term. reason =
IPCP: state = initial retransm = 10 term. reason =
=>pppoe ifdetach =intf=PPPoE1
=>pppoe iflist
PPPoE1: dest : PPPoE1
Retry: 10 QoS default encaps VC-MUX
mode = IP Routing
flags = echo magic accomp restart mru addr route savepwd PPPoEOA
trans addr = pat mru = 1492
route = 0.0.0.0/0 - 0.0.0.0/0 (metric 0)
user name = guest password = ********
admin state = down oper state = down link state = not-connected
LCP: state = initial retransm = 10 term. reason =
IPCP: state = initial retransm = 0 term. reason =
=>
pppoe ifadd Create a new PPPoE interface.
pppoe ifattach Attach a PPPoE interface.
pppoe ifconfig Configure a PPPoE interface.
pppoe ifdelete Delete a PPPoE interface.
pppoe iflist Show current PPPoE configuration.