Operation Manual

317
PPPoE Commands
E-DOC-CTC-20040210-0030 v1.0
EXAMPLE:
RELATED COMMANDS:
idletrigger Consider the link being idle if no traffic is sent and/or received during the
idle time. Choose between:
• RxTx: The idle time period restarts when a packet is transmitted or
received.
• Rx: The idle time period restarts when a packet is received.
Transmitted packets are ignored.
• Tx: The idle time period restarts when a packet is transmitted.
Received packets are ignored.
The default is RxTx.
OPTIONAL
addrtrans Automatically enable address translation for the IP address of this link
(pat) or do not use address translation (none). The default is none.
OPTIONAL
unnumbered Takes the local IP address from the laddr field and remote IP address from
the IP address pool assigned to the incoming PPPoE link.
In case the unnumbered parameter is disabled, the same IP address is
used for each connection on the server side, thus reducing the number of
used IP addresses.
OPTIONAL
=>pppoe iflist
PPPoE1: dest : PPPoE1
Retry: 10 QoS default encaps LLC
mode = IP Routing
flags = echo magic accomp restart mru addr route savepwd PPPoEOA
trans addr = pat mru = 1492
route = 0.0.0.0/0 - 0.0.0.0/0 (metric 1)
user name = My_Connection@MY_ISP password = ********
admin state = down oper state = down link state = not-connected
LCP: state = initial retransm = 10 term. reason =
IPCP: state = initial retransm = 0 term. reason =
=>pppoe ifconfig intf=PPPoE1 encaps=vcmux
=>pppoe iflist
PPPoE1: dest : PPPoE1
Retry: 10 QoS default encaps VC-MUX
mode = IP Routing
flags = echo magic accomp restart mru addr route savepwd PPPoEOA
trans addr = pat mru = 1492
route = 0.0.0.0/0 - 0.0.0.0/0 (metric 1)
user name = My_Connection@MY_ISP password = ********
admin state = down oper state = down link state = not-connected
LCP: state = initial retransm = 10 term. reason =
IPCP: state = initial retransm = 0 term. reason =
=>
pppoe ifadd Create a new PPPoE interface.
pppoe ifattach Attach a PPPoE interface.
pppoe ifdelete Delete a PPPoE interface.
pppoe ifdetach Detach a PPPoE interface.
pppoe iflist Show current PPPoE configuration.