Operation Manual

315
PPPoE Commands
E-DOC-CTC-20040210-0030 v1.0
servicename The Service Name for a PPPoE connection.
Use the command pppoe ifscan to see the available service names, if any.
OPTIONAL
pcomp Try (on) or do not try (off) to negotiate PPPoE protocol compression
(LCP PCOMP). The default is off.
OPTIONAL
accomp Try (on), do never try (off) or negotiate (negotiate) to negotiate PPPoE
address & control field compression (LCP ACCOMP).
In most cases, LCP ACCOMP should not be disabled nor negotiated, i.e.
the address field FF-03 should not be sent over ATM.
The default is on.
If the accomp parameter is set to 'negotiate', the local side of the PPPoE
connection demands to do ACCOMP and adapts itself to the result of this
negotiation.
OPTIONAL
trace Enable (on) or disable (off) verbose console logging.
The default is off.
OPTIONAL
concentrator The access concentrator is on this side of the PPPoE connection.
Choose between:
• on: the PPPoE connection is terminated on the Access
Concentrator (here the SpeedTouch™ itself)
• off: the SpeedTouch™ is PPPoE client.
The default is off.
OPTIONAL
auth Select the authentication protocol.
Choose between:
• pap: Password Authentication Protocol (PAP) authentication will be
forced.
• chap: Challenge Handshake Authentication Protocol (CHAP)
authentication will be forced.
• auto: CHAP authentication will be used. If CHAP authentication is
not successful, PAP authentication will be used instead.
The default is auto.
OPTIONAL
restart Automatically restart the connection when Link Control Protocol (LCP)
link goes down (on) or do not restart automatically (off).
The default is off.
OPTIONAL
retryinterval A number between 0 and 65535 (seconds).
Represents the intermediate interval between two retries to establish the
connection on ATM level. The default is 10.
OPTIONAL
passive Put the link in listening state in case LCP times out (on) or not (off).
This parameter allows to determine whether the link should be left open
to wait for incoming messages from the remote side after 10 unsuccessful
tries to establish the connection or not.
The default is disabled.
OPTIONAL
silent Do not send anything at startup and just listen for incoming LCP messages
(on) or retry up to 10 times to establish the connection (off).
The default is off.
OPTIONAL
echo Send LCP echo requests at regular intervals (on) or not (off).
The default is on.
OPTIONAL