Operation Manual

CLI Navigation

E-DOC-CTC-20040210-0030 v1.0

CLI Commands in Service Template Files

CLI commands in a paragraph of a Service Template file should always be constructed in their complete form.

Uncompleted CLI commands, i.e. commands in which required parameters are not specified, will be discarded by the

CLI commend interpreter. This may result in a wrongly configured SpeedTouch™.

In Service Template files, the use of customization variables allow the Setup wizard to invite the end-user to provide

some input regarding the settings of the SpeedTouch™. The declaration of such customization variables must be done

in the [env.ini] paragraph of the Service Template file. A preset (i.e. default) value can be declared for a

customization variable. Further use of these customization variables is allowed through all other paragraphs, even

several times.

When a customization variable is used in a CLI command, the value of the variable must always conform to the syntax

of the CLI command.

Customizing Service Template Files

For more information on the customization possibilities of the SpeedTouch™, the Setup wizard and the

configuration profile files, please check the SpeedTouch™ support pages at:

www.speedtouch.com

[pppoa.ini] The pppoa CLI command group

[pppoe.ini] The pppoe CLI command group

[pppoerelay.ini] The pppoe relay CLI command subgroup

[pptp.ini] The pptp CLI command group

[qos.ini] The qosbook CLI command group

[script.ini] The script CLI command group

[snmp.ini] The snmp CLI command group

[switch.ini] The switch CLI command group (only for SpeedTouch™ devices with a

four port switch).

[system.ini] The system CLI command group

[upnp.ini] The upnp CLI command group

[usb.ini] The usb CLI command group

[<configuration>.ini] paragraphs Available SpeedTouch™ CLI commands