Operation Manual

307
PPPoA Commands
E-DOC-CTC-20040210-0030 v1.0
pppoa rtdelete
Delete the route specification for a PPPoA link.
Note Use the command pppoa ifdetach for this interface prior to deleting route configurations.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
pppoa rtdelete intf = <intfname>
intf The PPPoA interface name for which to delete the route settings. REQUIRED
=>pppoa iflist
pppoa: dest : pppoa [00:00:00]
Retry : 10 QoS default encaps VC-MUX
mode = IP routing
flags = echo magic accomp restart mru addr route savepwd
dns metric = 0 trans addr = pat mru = 1500
route = 10.0.0.2/24 - 172.16.0.5/24 (metric 1)
auth = auto user = johndoe@ISP password = ********
admin state = up oper state = down link state = not-connected
LCP : state = starting retransm = 1 term. reason =
IPCP: state = initial retransm = 0 term. reason =
=>pppoa rtdelete intf=pppoa1
=>pppoa iflist
pppoa_pppoa: dest : pppoa [00:00:00]
Retry : 10 QoS default encaps VC-MUX
mode = IP routing
flags = echo magic accomp restart mru addr route savepwd
dns metric = 0 trans addr = pat mru = 1500
auth = auto user = johndoe@ISP password = ********
admin state = up oper state = down link state = not-connected
LCP : state = starting retransm = 1 term. reason =
IPCP: state = initial retransm = 0 term. reason =
=>
pppoa rtadd Configure a route specification for an upcoming PPPoA link.