Operation Manual

304
PPPoA Commands
E-DOC-CTC-20040210-0030 v1.0
pppoa iflist
Show current configuration of a specific or all PPPoA interface(s).
SYNTAX:
where:
EXAMPLE INPUT/OUTPUT:
RELATED COMMANDS:
pppoa iflist [intf = <intfname>]
intf The name of the PPPoA interface for which the configuration must be
shown.
If this parameter is not specified, all PPPoA interfaces are shown.
OPTIONAL
=>pppoa iflist
pppoa: dest : pppoa [00:00:00]
Retry : 10 QoS default encaps VC-MUX
mode = IP routing
flags = echo magic accomp restart mru addr route savepwd
dns metric = 0 trans addr = pat mru = 1500
route : dst=0.0.0.0/0 - src=10.0.0.0/1 (metric 1)
auth = auto user = johndoe@ISP password = ********
admin state = up oper state = up link state = connected
LCP : state = starting retransm = 1 term. reason =
IPCP: state = initial retransm = 0 term. reason =
pppoa2: dest : pppoa2 [00:00:00]
Retry : 10 QoS default encaps VC-MUX
mode = IP routing
flags = echo magic accomp restart mru addr savepwd
dns metric = 0 mru = 1500
auth = auto user = password =
admin state = down oper state = down link state = not-connected
LCP : state = initial retransm = 10 term. reason =
IPCP: state = initial retransm = 0 term. reason =
=>
pppoa ifadd Create a new PPPoA interface.
pppoa ifattach Attach a PPPoA interface.
pppoa ifconfig Configure a PPPoA interface.
pppoa ifdelete Delete a PPPoA interface.
pppoa ifdetach Detach a PPPoA interface.