Operation Manual

280
NAT Commands
E-DOC-CTC-20040210-0030 v1.0
nat list
Lists NAT/PAT connection database.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
nat list [addr = <ip-address>]
addr An address-translation enabled IP address.
Note If no address is specified, all IP addresses are shown.
OPTIONAL
=>nat list
Indx Prot Inside-addr:Port Outside-addr:Port Foreign-addr:Port Flgs Expir State Control
1 6 10.0.0.138:80 172.16.0.5:1080 0.0.0.0:0 19 8 9
2 17 10.0.0.138:138 10.0.0.140:138 10.0.0.20:138 11 20 10
3 17 10.0.0.138:137 10.0.0.140:137 10.0.0.254:137 11 20 10
4 17 10.0.0.138:7938 10.0.0.140:7938 10.0.0.96:4756 11 20 10
5 17 10.0.0.138:513 10.0.0.140:513 10.0.0.109:513 11 20 10
6 17 10.0.0.138:111 10.0.0.140:111 10.0.0.96:4756 11 20 10
=>
nat create Create a static NAT/PAT entry.
nat delete Delete a static NAT/PAT entry.
nat disable Disable NAT/PAT on a SpeedTouch™ IP address.
nat enable Enable NAT/PAT on one of the SpeedTouch™ IP addresses.