Operation Manual

270
NAT Commands
E-DOC-CTC-20040210-0030 v1.0
nat config
Configure NAT parameters for IP session.
SYNTAX:
where:
EXAMPLE:
nat config [timeout_ICMP = <string>]
[timeout_UDP = <string>]
[timeout_TCP = <string>]
[timeout_TCP_nego = <string>]
[timeout_other = <string>]
[ike_port = <{fixed|floated}>]
timeout_ICMP The interval of time for which an ICMP protocol session is allowed
to remain valid without any activity.
Syntax: <HH:MM> or <MM>.
OPTIONAL
timeout_UDP The interval of time for which an UDP protocol session is allowed
to remain valid without any activity.
Syntax: <HH:MM> or <MM>.
OPTIONAL
timeout_TCP The interval of time for which an TCP protocol session is allowed
to remain valid without any activity. This timeout value applies to a
TCP session during its data transfer phase.
Syntax: <HH:MM> or <MM>.
OPTIONAL
timeout_TCP_nego The interval of time for which an TCP protocol session is allowed
to remain valid without any activity. This timeout value applies to a
TCP session during its establishment and termination phases.
Syntax :<HH:MM> or <MM>.
OPTIONAL
timeout_other The interval of time for which an IP session for a protocol other
than ICMP, UDP and TCP is allowed to remain valid without any
activity.
Syntax: <HH:MM> or <MM>.
OPTIONAL
ike_port The IKE outside port number. This is the translation port number
for IKEv1 (fixed to 500 or floated).
OPTIONAL
=>nat config
Timeout ICMP idle : 00h01m
Timeout UDP idle : 00h05m
Timeout TCP idle : 00h15m
Timeout TCP negotiation idle : 00h02m
Timeout Other idle : 00h01m
IKE outside port number : Floated
=>