Operation Manual

254
Label Commands
E-DOC-CTC-20040210-0030 v1.0
prot The protocol (name or number) expected in the IP packet.
Select one of the following protocol names:
• icmp
• igmp
• ipinip
• tcp
• udp
• ah
• esp
• ipcomp
or, alternatively, specify the protocol number.
OPTIONAL
srcport The TCP/UDP port (or beginning of range) the packet is coming
from.
Select one of the supported TCP/UDP port names (See
“ Supported TCP/UDP Port Names” on page 412 for a listing of
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
OPTIONAL
srcportend The source TCP/UDP port range end (inclusive) (only applicable for
ranges).
Select one of the supported TCP/UDP port names (See
“ Supported TCP/UDP Port Names” on page 412 for a listing of
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
OPTIONAL
dstport The TCP/UDP port (or beginning of range) the packet is going to.
Select one of the supported TCP/UDP port names (See
“ Supported TCP/UDP Port Names” on page 412 for a listing of
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
OPTIONAL
dstportend The destination TCP/UDP port range end (inclusive) (only
applicable for ranges).
Select one of the supported TCP/UDP port names (See
“ Supported TCP/UDP Port Names” on page 412 for a listing of
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
OPTIONAL
clink The name of the chain to be parsed when this rule applies. OPTIONAL
log Logging is done when this rule applies.
Choose between no or yes.
OPTIONAL
label Choose between:
• None
• link (when clink is used)
• label name.
REQUIRED