Operation Manual

206
IP Commands
E-DOC-CTC-20040210-0030 v1.0
ip rtadd
Add a route to the SpeedTouch™ routing table.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
ip rtadd dst = <ip-address>
[dstmsk = <ip-mask(dotted or cidr)>]
[label = <string>]
[gateway = <ip-address>]
[intf = <interface name>]
[metric = <number{0-100}>]
dst The destination IP address(es) for this route.
Supports cidr notation.
REQUIRED
dstmsk The destination IP address mask. OPTIONAL
label The name of the label. OPTIONAL
gateway The IP address of the next hop. Must be directly connected.
Note The parameters gateway and intf are mutually exclusive.
OPTIONAL
intf Only for special interface routes: the outgoing IP interface name.
Note The parameters gateway and intf are mutually exclusive.
OPTIONAL
metric The metric for this route (weight factor). OPTIONAL
=>ip rtlist
Destination Label Gateway Intf Mtrc Status
10.0.0.0/24 10.0.0.140 eth0 0 [UP]
10.0.0.140/32 10.0.0.140 eth0 0 [UP]
127.0.0.1/32 127.0.0.1 loop 0 [UP]
=>ip rtadd dst=10.10.0.0/24 src=10.0.0.0/24 gateway=10.0.0.140
=>ip rtlist
Destination Label Gateway Intf Mtrc Status
10.0.0.0/24 10.0.0.140 eth0 0 [UP]
10.10.0.0/24 10.0.0.140 eth0 0 [UP]
10.0.0.140/32 10.0.0.140 eth0 0 [UP]
127.0.0.1/32 127.0.0.1 loop 0 [UP]
=>
ip rtdelete Remove a route from the routing table.
ip rtlist Show current routing table.