Operation Manual

CLI Navigation

E-DOC-CTC-20040210-0030 v1.0

Accessing the Command Line Interface

Users can access the Command Line Interface via a Telnet session. This requires that TCP/IP connectivity exists

between the host from which the Telnet session is opened and the SpeedTouch™.

.Proceed as follows to open a Telnet session:

1 Open a Command Prompt window, e.g. by clicking Start > All Programs > Accessories > Command Prompt.

2 At the prompt, type telnet followed by the IP address of the SpeedTouch™ (default is 10.0.0.138).

As soon a session to the CLI is opened, the SpeedTouch™ banner pops up, followed by the CLI prompt.

If the SpeedTouch™ is protected by a username and a system password, authentication will be required before access is

granted.

The following figure shows an example of the SpeedTouch™510 banner after opening a session and authentication.

Username : johndoe

Password : *******

------------------------------------------------------------------------

* ______ SpeedTouch 510

* ___/_____/\

* / /\\ Version 4.2.7.0

* _____/__ / \\

* // / \ /\ \ THOMSON

* _______//_______/ \ / _\/______

* / /\ \/// /\

* __/ / \ \ / / / / _\__

* / / / \_______\/ / / / / /\

* /_/______/___________________/ /________/ /___/ \

* \ \ \ ___________ \ \ \ \ \ /

* \_\ \ / /\ \ \ \ \___\/

*\ \/ /\\\ \/

* \_____/ / \ \ \________\/

* /__________/ \ \ /

* \ _____ \ /_____\/

* \ / /\ \ /___\/

* /____/\\/

* \ \ /___\/

* \____\/

------------------------------------------------------------------------