Operation Manual

158
ETHoA Commands
E-DOC-CTC-20040210-0030 v1.0
ethoa ifattach
Attach (i.e. connect) an ETHoA interface.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
ethoa ifattach intf = <intfname>
intf The name of the ETHoA interface to attach. REQUIRED
=>ethoa iflist
Newethoa : dest : Br3
Retry : 10 QoS : default Encaps : llc/snap Fcs : off
Connection State : connected
RX bytes: 0 frames: 0
TX bytes: 0 frames: 0 dropframes: 0
Moreethoa : dest : Br4
Retry : 10 QoS : default Encaps : llc/snap Fcs : off
Connection State : not-connected
=>ethoa ifattach intf=Moreethoa
=>ethoa iflist
Newethoa : dest : Br3
Retry : 10 QoS : default Encaps : llc/snap Fcs : off
Connection State : connected
RX bytes: 0 frames: 0
TX bytes: 0 frames: 0 dropframes: 0
Moreethoa : dest : Br4
Retry : 10 QoS : default Encaps : llc/snap Fcs : off
Connection State : connected
RX bytes: 0 frames: 0
TX bytes: 0 frames: 0 dropframes: 0
=>
ethoa ifadd Create a new ETHoA interface.
ethoa ifconfig Configure an ETHoA interface.
ethoa ifdelete Delete an ETHoA interface.
ethoa ifdetach Detach an ETHoA interface.
ethoa iflist Show current ETHoA interfaces.