User's Manual

- OR -
Pick up the handset and press the TALK button.
2. When finished, press END/cancel to hang up.
NOTE: Adjust the handset volume by pressing the caller ID-volume (6 or 5) button during a call.
Call Timer
After you press the TALK or SPEAKER button on the handset, the built-in call timer shows on the display and
counts the length of time of the call in minutes and seconds.
Auto Standby
If you place the handset in the cradle while the handset is off the hook (during a call), the call is automatically
disconnected.
Ringer Volume (Shortcut)
There are two ways to set the ringer volume. One is the traditional way as described in the Programming
Functions; Handset Setup; Ringer Volume menus. The other one is this short cut to ringer menu.
1. Make sure the phone is OFF (not in TALK mode).
2. Press the #pause button to display SET RINGER LEVEL 5.
3. Use the caller ID-volume (6 or 5) button to scroll to your selection. LEVEL 5 is the default setting.
4. Press #pause button again to save and display the new selection for a few seconds.
Flash/Call Waiting
If you subscribe to the combined Call Waiting Caller ID service from your local telephone company, you will
receive Caller ID information (if available) on Call Waiting calls. During a phone call, you will hear a beep to
indicate another call is waiting on the line and Caller ID information for the waiting call shows on the handset
display.
• To connect to the waiting call, press the TALK or SPEAKER button on the handset, and your original call is put
on hold.
• To switch between the two calls, press the TALK or SPEAKER button.
Last Number Redial
You may redial a number up to digits long. To quickly redial the last number you dialed:
1. Press the TALK or SPEAKER button.
2. Press the redial/format button.
-OR-
3. Press the redial/format button first, then use the caller ID-volume (6 or 5) button to select the desired redial
number.
- Press the caller ID-volume (5) to review the oldest call and scroll toward the most recent calls (higher
numbers).
- Press the caller ID-volume (6) to review the newest call and scroll to older calls (lower numbers).
NOTE: You may choose from three last dialed numbers.
4. Press the TALK or SPEAKER button. The number dials automatically.
If you get a busy signal and want to keep dialing the number, press the redial/format button to quickly redial the
number.
Exit
Press the END/cancel button to exit a menu function and return to the standby screen.
Page
The page feature helps you locate a misplaced handset. To send and receive pages, all handsets must be
registered. If your handset is not registered, follow the instructions in the Registration section of this manual.
Handset to Handset Paging
(applicable only with additional handsets)