Manualshelf

User's Manual

ManualsBrandsThomson ManualsAudio EquipmentDECT 6.0 CORDLESS HANDSET SPEAKERPHONE/ANSWERING S
81828384858687888990
below to return to the factory default settings.
From the Handset Setup Menu:
1. Press the caller ID-volume (6 or 5) button to scroll to the DEFAULT SETTING sub-menu.
2. Press the mute/menu OK button to enter the menu. DEFAULT SETTING 1YES 2NO shows in the display. The
default setting is 2NO.
3. Use the touch-tone pad to select 1YES or 2NO, or use the caller ID-volume (6 or 5) button to move the
cursor to 1YES or 2NO.
NOTE: If you choose YES all the settings in the programmable menu are returned to factory default
setting.
4. Press the mute/menu OK button to save your selection. You will hear a confirmation tone.
Telephone Operation
Visual Indicators
Base
The charge/in use voicemail indicator on the base will flash to alert you to an incoming call, during paging, or if
you have a message waiting from your service provider. The indicator will remain lit when a handset is in the base
charging or when the line is in use.
Handset
The TALK and SPEAKER indicator buttons flash when you receive a call and remain lit during a call.
The keypad and CID will also light when a call is received.
VMWI / Visual Ringer Indicator on Handset
IMPORTANT: In order to use this unit’s Voice Mail Waiting Indicator (VMWI) feature, you must
subscribe to this service from your phone company.
The VMWI indicator on the top of the handset flashes when you receive a new message from your service
provider. Also, it serves as a Visual Ringer function. It will flash when there is an incoming call.
Speakerphone Operation
NOTE: If you are using the speakerphone, remain close to handset so the party you are speaking to
can hear you.
If you are using the handset and want to switch to the speakerphone, press the SPEAKER button, press
END/cancel to end conversation.
If you are using the speakerphone and want to switch to the handset, press the TALK button, press END/cancel
again to end conversation.
Making a Call
1. Press the TALK or SPEAKER button. Dial the desired number.
- OR -
Dial the number first, then press the TALK or SPEAKER button.
- OR -
Press the caller ID-volume (6 or 5) button to select the desired record, then press the TALK or SPEAKER
button.
2. When finished, press the END/cancel button to hang up.
NOTE: You may enter up to 32 pre-dial digits.
NOTE: If you want to delete the pre-dial number you entered, press the delete/intercom/conf button
until all of the digits are erased.
Answering Calls
1. When the phone rings, press the SPEAKER button on the handset.