User's Manual

6. Press mute/menu OK button to confirm and then display VIP MELODY 01 to wait for the melody tone selection.
7. Press caller ID-volume (6 or 5) button to select from melody 01 to melody 10 (a testing tone is generated
while making melody selection)
8. Press mute/menu OK button to confirm.
NOTE: If the desired number/record was previously stored in any one of the ten VIP melody records,
DUPLICATE NUMBER shows in the display.
Changing a Stored VIP Melody Record
Use the Storing VIP Melody procedure to change the number of a selected record and replace the old phone
number with new phone number.
When REPLACE VIP# ? shows in the display, you must press mute/menu OK button on the handset to confirm
replacement.
Reviewing and Deleting Stored VIP Melody Record
From the Handset Setup Menu:
1. Press the mute/menu OK button to enter to VIP MELODY menu.
2. Use the caller ID-volume (6 or 5) button to scroll to the desired VIP Melody Record.
3. If you want to delete the information, press the delete/intercom/conf button on the handset while the entry
displays. The display show DELETE VIP# ?.
4. Press delete/intercom/conf again to confirm. You will hear a confirmation tone and VIP# DELETED shows in
the display.
Key Tone
From the Handset Setup Menu:
1. Press the caller ID-volume (6 or 5) button to scroll to the KEY TONE sub-menu.
2. Press mute/menu OK button to enter the menu. SET KEY TONE 1ON 2 OFF shows in the display.
3. Use the touch tone pad on the handset to select 1 or 2, or use the caller ID-volume (6 or 5 ) button to scroll to
your selection. 1ON is the default setting.
4. Press the mute/menu OK button to confirm and the key tone setting shows in the display.
Area Code
From the Handset Setup Menu:
1. Press the caller ID-volume (6 or 5) button to scroll to the AREA CODE sub-menu.
2. Press mute/menu OK button to enter the menu. SET AREA CODE - - - shows in the display.
3. Use the touch-tone pad to enter your -digit area code.
4. Press the mute/menu OK button to confirm. You will hear a confirmation tone and the new area code shows in
the display.
NOTE: To restore the default setting to - - -, press and release delete/intercom/conf when SET AREA
CODE shows in the display.
Tone/Pulse
From the Handset Setup Menu:
1. Press the caller ID-volume (5 or 6) button to scroll to the TONE PULSE sub-menu.
2. Press mute/menu OK button to enter the menu. TONE/PULSE 41TONE 2PULSE shows in the display. The
default setting is “1 TONE”.
3. Use the touch-tone pad or caller ID-volume (5 or 6) to enter 1 TONE or 2 PULSE.
4. Press the mute/menu OK button to confirm. You will hear a confirmation tone and your selection shows in the
display.
Registration
Your packaged handset(s) are pre-registered and ready to use. It is not recommended that a handset be
registered again unless absolutely necessary.
From the Handset Setup Menu: