User's Manual

15
Connect Cables
Connect one end of the coaxial cable to the cable connection on the
wall, and the other end to the CABLE connector on the Advanced
Cable Gateway.
Connect one end of the power cord into the 120V, 60Hz, 0.5A socket
on the Advanced Cable Gateway and the other end into the power
plug in the wall.
Connect one end of the Ethernet cable (straight-wired, see below) to
the Ethernet port on the back of your computer and the other end to
the ETHERNET port on the Advanced Cable Gateway.
Note: The Gateway is equipped with two Ethernet ports, making
additional equipment unnecessary.
If you want to create hard wired connections to the ACG for more than
two computers, you will need to purchase a Hub (Switch) for that purpose
and the cabling necessary for those additional connections. Although a
10BaseT Hub or Switch can be used, it is not recommended. A 100BaseT
Hub or Switch is recommended. Follow the installation guidelines that
accompany this equipment.
Connect More Than Two Computers with Ethernet Cables
Connect Telephone or Fax with Standard Analogue Phoneline
When properly connected, most telephone devices can be used with the
Advanced Cable Gateway. Here is how to make that connection
Note: If you have any questions concerning telephone connection, please
contact your service provider.
Note: There is only one TEL connection available on the rear panel of the
Gateway.
analog
phone
Advanced
Cable
Gateway
Connect a standard phone line cord
directly from the phone (fax machine,
answering machine, caller ID box,
etc.) to the TEL port on the Gateway.
To make a normal telephone call,
pick up the handset; listen for a dial
tone, then dial the desired number
using this new connection. For
services such as call waiting, use
the hook switch (or FLASH button)
to change calls.