User's Manual

29
Activate
Activating Services
LED LABEL
Power
Battery
( LED desc.
when battery
is inserted )
DS/US ONLINE LINK TEL
Boot Up
Operation
Power On during 0.25s
OFF ON ON ON ON ON
From Power On to System
Synchronization complete
ON ON
SLOW
BLINK
SLOW
BLINK
OFF OFF
Before DS scanning:
during 1s
ON ON ON ON X* OFF
DOCSIS Start-Up Operation
Note 1
DS scanning & acquiring
SYNC
ON ON
FAST
BLINK
OFF X OFF
From SYNC completed,
receiving UCD to ranging
completed
ON ON
SLOW
BLINK
OFF X OFF
DHCP
ON ON ON
FAST
BLINK
X OFF
cong le download
ON ON ON
SLOW
BLINK
X OFF
Registration & BPI
initialization
ON ON
FAST
BLINK
FAST
BLINK
X OFF
Operational (NACO On)
ON ON ON
ON
X OFF
Operational (NACO Off)
ON ON ON
OFF
X OFF
Telephone
Provisioning
ON ON ON
ON
X
FAST
BLINK
Registered
ON ON ON
ON
X ON
Not available
ON ON ON
ON
X OFF
LAN Active
No Ethernet or WiFi Link
ON ON ON
ON
OFF X
Ethernet or WiFi Link
ON ON ON
ON
ON X
Tx/Rx Ethernet or WiFi
Trafc
ON ON ON
ON
SLOW
BLINK
X
ACG in dect association
mode = Page button has
been pressed for more
than 12s
ON ON ON
ON
FAST
BLINK
X
* “X” indicates that this LED is not used to show the state of operation described on this line.
Check in this column for the state in which this LED is ON.
Note 1- “Flash” indicates a CM or EMTA initialization process in progress.
A “Flash” that does not stop indicates an initialization error.
Note 2- During an AC Power Failure with a bad battery, the operation of the device
may not be possible due to lack of battery power; all LEDs may be “Unlit”.