User's Manual

15
Parts and Putting them Together
Assemble
Inserting Batteries
To install batteries into the Advanced Cable Gateway:
Ensure the power cord is 1.
unplugged. Remove the battery
cover on the rear panel. There
are two battery compartments.
One battery is included with the
Advanced Cable Gateway.
For an additional battery please
contact your local operator.
Push the slider up/down to allow 2.
for battery insertion.
Insert the battery into the 3.
compartment marked
“Battery 1”.
Readjust the slider to prevent the 4.
battery from moving and replace
the battery cover. Plug the power
cord into an electrical outlet that
is not controlled by a wall switch
(this will assure that the unit has
uninterrupted power). The battery
will fully charge within 5 hours.