User's Manual

Other Information

7. Validate the base association by pressing KEY_

SOFT_1. “Handset Registered” is displayed and the

handset goes back to idle.

8. The DECT LED of the Base stops to ﬂash when a HS

has successfully been registered of after the time

out (~90s)

If the handset does not locate the base, it goes back

to idle mode. Try again and make sure there is no

environmental interferences.

If the handset emits a double beep, it means that the

base has the maximum of 5 subscribed handsets.

You can erase the previous subscription by asking a

new registration from the same handset.

Changing the Battery

CAUTION: To reduce the risk of ﬁre or personal

injury, use only the Thomson Inc. approved model

GP 75AAAHC 1.2V 750mAh, rechargeable Nickel-metal

Hydride AAA batteries, which are compatible with

this unit.

1. Make sure handset is OFF (not in TALK mode) before

you replace battery.

2. Remove the battery compartment door.

3. Remove the batteries from the handset.

4. Insert the new batteries.

5. Put the battery compartment door back on.

6. Place handset in the base or handset charge cradle

to charge. Allow the handset battery to properly

charge (for 16 hours) prior to ﬁrst use or when

you install a new battery pack. If you do not

properly charge the phone, battery performance

will be compromised.

NOTE: The RBRC seal on the battery used in your Thomson Inc. product

indicates that we are participating in a program to collect and recycle the

rechargeable battery (or batteries).

For more information go to the RBRC web site at www.rbrc.org

or call 1-800-8-BATTERY or contact a local recycling center.