User's Manual

4
Unit beeps
• Clean charging contacts on cordless handset.
• See solutions for “No dial tone”.
• Replace the battery.
Memory Dialing doesn’t work
• Did you program the memory location keys correctly?
• Did you follow proper dialing sequence?
Unit locks up and there is no communication between the base and cordless handset
• Unplug the USB cable and the AC power adaptor from the wall outlet and the
back of the base. Remove the handset battery. Wait for 30 seconds and plug
the power adaptor back into the base and wall outlet. Reconnect the battery and
charge for 16 hours.
Handset displays "SEARCHING" or "OUT OF RANGE" and cannot link up with the base
when the TALK/CALL BACK button is pressed.
• Handset may be out of range of the base. Move closer to the base.
• Make sure the power adaptor is properly installed.
• Disconnect the handset battery and plug it in again. Place the handset on the
cradle for at least  to 3 minutes.
• Disconnect the power adaptor and plug it in again. Then place the handset on
the cradle for at least  to 3 minutes.
Handset displays "HANDSET NEEDS REGISTRATION"
• Follow the programming in the telephone procedures to re-register the handset
to the base.
• Press the SELECT button to begin handset registration. Follow instructions on
Handset screen.
Registration did not work
• Charge the batteries for 16 hours.
• Uplug and then plug in the power adaptor.