INTRODUCTION CAUTION: When using telephone equipment, there are basic safety instructions tat should A always be followed, Refer to the IMPORTANT SAFETY INSTRUCTIONS provided with this product and save them for future reference. Your cordless telephone is designed to give you flexibility in use and high quality performance.
Base Handset Handset Mounting AC power supply effeteness une Cora ° battery bracket Modular Jack REQUIREMENTS 5 You need an REJOICE type modular phone jack, which is the mast common type of pane jack and might ® took fiche the one pictured here. If you don't have 8 modular jack, call your local phone company to find out how tu get ong installed.
% CONNECTING THE AC (ELECTRICAL) POWER Plug thé power supply card into the power sick on the bottom of the base and the bather end into an electrical outlet. The charge fin use indicator turns on to indicate the battery is charging. Allow the phone to charge for 12 hours prior to first use, If you don't properly charge the phone, battery performance will be compromised, (A CAUTION: Use only the AT LINKS USA, Inc. 52527 (black) or 5-259 ( white) power supply that came with this unit.
1. Turn the base over. 2. Attach the wall mounting pedestal by first inserting the tabs on the open adj of the pedestal into the slots on the lawyer portion of the bottom of the base. Then push down and snap the pedestals! into place. 3. Sip the mounting holes {on the back of the base and pedestal) aver the wall plate posts and slide the iit down into place. (Wall plate not included.) CORDLESS PHONE Basics vol button TALK o redial button memory button : *TONE button.
Toneless Dina This adjustment allows you to select tone {touch-tame} ar pulse {rotary} mads dialing. The phone is automatically set for taus-tone uss. To set tone or pulse dialing: 1. Make aura the phone is OFF. 2. Press and hold the program (prig) button until the unit beeps, 3. Press * for TONE or # for PULSE, 4. Press the program {prig} button again. You will hear a confirmation tone.
3 RULE UES a USS 2100 Ui (ALR ADJUDICATORY ON ThE handset 2nd the cheeseparing uss indicator on the base blinks, Press the TALK button wham you Locate the handset. The page signal is three beeps every two seconds for two minutes. Press the bees PAGE button to stop paging. (NOTE: You can steel page the handset with the ringer off, CD) Can Burton 1 you ever experience any interference or font have clear voice quality, press the Chan button on the handset to advance to soother channel.
Dialing a Loren Nurser 1 Make sure the hons is ON by pressing the TALK button. 2. Press tha memory button, 3. Press the number {0-9} for the desired memory location. The umber dials automatically, and briefly explain the reason for the call to the dispatcher, Also, it's a good idea to make these calls IMPORTANT: If you make test calls to emergency numbers stored in memory, remain on the line in off peak hours, such as early morning or late evening.
, ACL oe sos 0 USE SUCTION BOOK, J BATTERY SAFETY PRECAUTIONS « Do not burn, disassemble, mutilate, or puncture. Lila other batteries of this tps, toxic materials could be released which ean cause injury. * To reduce the risk of fire or personal injury, use ably the battery listed in the User's Guide. i «Keep batteries out of the reach of children. * Remove batteries i staring over 30 days. NOTE: The CURB sea] on the battery used in your AT LINKS USA, Inc.
Battery will not hold a charge* Phone dials in pulse with tone service, © Be sure you sufficiently charge the battery {for 12 hours), and you can expect approximately 4 hours of talk time. + Check to be sure battery contacts on both the handset and the base are making contact and are clean; free of dirt or lint, + When the handset is placed in the base, check that the base charge/in use indicator is on. * Make sure the dial mode is set to TONE.
uk and the handset the battery pack. Place the handset in the base for 10 seconds to reset power outage occurs while the handset is away . from the base, return the handset to the base when the power returns. Limit Ed WARRANTY ee What tout warranty coves + Detects in materials or workmanship For how [ong after your purchases; * One year, from date of purchase, {The warranty period for rental units begins with the first rental or 45 days laundromats of shipment to the rental firm, whichever comes first.
El SERVICE This product may be serviced only by the manufacturer or its authorized service gents, Chang's or modification fot expressly approved by AT LINKS USA, Inc. could void the user's authority t persists this product, For . instructions on how to obtain service, refer to the warranty included in this guide or call customer service at 1-800-448-0329. Or refer inquiries to: AT LINKS USA, Inc.
Ya BELL HU MODEL NO, PRICE* | QUANTITY § TOTAL black | white AC power supply 52527 | 5-252 | $1550 Replacement battery 5.2459 $14.95 To order, Cali 806-338-0376 for accessories only) or complete thi order form.
