User's Manual Part 2

Digital Liquid Cooled UHF
TV Equipment
Use of commands and description of indicators
Information contained is this document is confidential, is THOMSON property and cannot be disclosed in whatever form without prior written authorization of THOMSON.
2.1.2.2. "TRANSMITTER INTERFACE PARAMETERS" window
This window appears when the changeover switch SW1 on the exciter/CPU interconnection card
(MODAP) or on the management system interconnection card (SIRIUS) is switched so that the dot is
visible and that CPU board is reset.
It is called up by pressing the "INSTALL NEXT" control keys in the "INSTALLATION PARAMETERS
Level 1" window.
This window is used to change the transmitter interface parameters stored in the CPU card.
CONTROL KEYS FUNCTIONS SELECTIONS
AVAILABLE/COMMENTS
Selects the transmitter ID number in N+1 or
Passive Reserve configurations.
Displays last selection.
he transmitter ID number is used for remote
control through an RS 232/485 connection.
Pressing this key calls up the "NUMERICAL
ALUE" window in which this two-digit
identification number can be changed.
T
V
Selects the type of JBUS protocol operation
for remote control
Displays last selection
JBUS ASCII
JBUS RTU
Selects the type of remote operation.
Displays last selection.
SERIAL RMT CTRL, PARALLEL RMT
CTRL, USER RMT CTRL
Calls up the "CABINET CONFIGURATION
PARAMETERS" window.
9932 V2
45321648.01 108 B E
Checked
44 / 192
Numéro / Number Doc. Rev. Lan
g
u.
27/06/2006
Pa
g
e