User's Manual Part 1

ManualsBrandsThomson Broadcast & Multimedia ManualsElectronicsUHF Digital transmitter, for use with MediaFlo

Digital Liquid Cooled UHF

TV Equipment

Exploitation

Information contained is this document is confidential, is THOMSON property and cannot be disclosed in whatever form without prior written authorization of THOMSON.

ACTIONS CONSEQUENCES

Leaving the

installation mode

♦ Press the valid key in the

"INSTALLATION PARAMETERS Level 1"

window,

♦ The transmitter stores the new configuration

parameters.

♦ Set switch SW1, situated in the

exciter/CPU interconnection card, such

that the dot is not visible,

♦ The system is initialised with the new status and

operational parameters.

♦ Reset the CPU board.

♦ The "STATUS" window appears and indicates

that the system is in normal operating mode.

1.6.3. Pro

Having alre d n maintenance mode and also having unlocked the PCL and

called up the

cedure for adjusting the required transmitter power

a y configured the system i

"TRANSMITTER STATUS" window, carry out the following operations :

ACTIONS RESULT

Select the required

♦ In NSMITTER STATUS" ♦ The "REQUIRED indow appears.

power value

the "TRA

window, press on the "REQUIR POWER"

key

♦

POWER" w

The current value is displayed under the window

title.

1 - To insert the

required p er value

♦ Enter the required value on the window

♦

keyboard,

Press "ENTER" to validate the entry.

IM ORTANT :

Range of variation:

0.25 *Cal Pwr

< REQ Pwr < 1.12 Cal

Pwr and

REQ Pwr

< MAX Pwr

ncelling the selection: Ca

nder the

The system activates the new power reduction

value.

♦ The new current value is displayed u

window title

♦

QUIRED ♦

♦ res the new power reduction

♦ Press “CANCEL” key in the "RE

POWER" window.

The "TRANSMITTER STATUS" or "RF LEVEL”

window appears.

The system igno

value.

2 - Select the

reduction value:

♦ In the "POWER REQUIRED" window,

y successively

uction value is

displayed

♦ values of power reduction appear

the

♦ m activates the new power reduction

value.

required power

press on the "x dB" ke

until the required power red

♦ Press the "ENTER" key for Validation of

selection:

Cancelling the selection:

The available

successively on the key. he key flashes until

selection is validated.

♦ The "x DB" key stops flashing and remains lit.

The syste

♦ ♦ The "TRANSMITTER STATUS" or "RF LEVEL”

window appears.

♦ The system ignores the new power reduction

value.

Press “CANCEL” key in the "REQUIRED

POWER" window.

9932 V2

45321648.01 108 B E

Checked

24 / 192

Numéro / Number Doc. Rev. Lan

27/06/2006