User's Manual Part 1

Digital Liquid Cooled UHF
TV Equipment
Exploitation
Information contained is this document is confidential, is THOMSON property and cannot be disclosed in whatever form without prior written authorization of THOMSON.
1.5. Procedure to activate "SNMP" or "WEB" agent
Each option is associated with an activation code. Each code is single and associated with one CPU
board. The identification r of the CPU board is given on the “ET INSTALLATION
PARAMETERS” win o
W (
numbe HERNET
d w. With this number you can get the
ask for THALES).
activation code of the SNMP agent and/or
EB agent option
ACTIONS RESULT
To call up the
"INSTALLATION
PARAMETERS
Level 1" window
situated in the
ction card on the
side of the sub-units behind the CPU
card, such that the dot is visible.
♦ Reset the CPU board
♦ e.
♦ The "INSTALLATION PARAMETERS Level 1"
window appears on the PCL and displays the
current transmitter configuration parameters.
♦ Set switch SW1,
exciter/CPU interconne
The transmitter is switched to installation mod
To call up the
"ETHERNET
INSTALLATION
PARAMETERS"
window of the PCL
♦ Press "INSTALL NEXT" in the
"TRANSMITTER INTERFACE
INSTALLATION PARAMETERS",
"CABINET CONFIGURATION
PARAMETERS" and "INSTALLATION
ADAPT PARAMETERS" window.
♦
The "ETHERNET INSTALLATION
PARAMETERS" window appears on the
PCL and displays the current configuration
parameters.
Set the Ethernet
network parameters
♦ IP address of the transmitter,
♦ Sub-net mask number,
♦ IP address of the gateway.
♦ Refer to procedure § “Procedure for
inserting Ethernet network parameters”
IMPORTANT :
• The NetWare parameters must be
furnished by your network
administrator.
• Setting bad parameter disturbs the
network.
To insert the
activation code
♦ Press on the control keys of the code to
be inserted,
♦ Enter the required value on the window
keyboard,
♦ Press "ENTER" to validate the entry.
IMPORTANT :
• Enter a bad code leads the control
keys display to cone back to “0”.
♦ The "NUMERICAL VALUE" window appears.
♦ The value is displayed under the window title.
♦ The "INSTALLATION PARAMETERS" window
appears.
♦ The value is displayed on the control keys.
♦ The "INSTALLATION PARAMETERS" window
appears.
Note:
To cancel and entry press the "CANCEL"
key.
♦ The value remains unchanged
Calls up the
"INSTALLATION
PARAMETERS
Level 1" for validation
♦ Press "INSTALL NEXT" in the
"ETHERNET INSTALLATION
PARAMETERS" window.
♦ The "INSTALLATION PARAMETERS Level 1"
window appears on the PCL.
9932 V2
45321648.01 108 B E
Checked
21 / 192
Numéro / Number Doc. Rev. Lan
g
u.
27/06/2006
Pa
g
e