User's Manual Part 1

Digital Liquid Cooled UHF
TV Equipment
Exploitation
Information contained is this document is confidential, is THOMSON property and cannot be disclosed in whatever form without prior written authorization of THOMSON.
1.4. Procedure for inserting Ethernet network parameters
The following parameters of the Ethernet network can be inserted in the “ETHERNET INSTALLATION
PARAMETERS” window L :
♦ IP f the a
♦ Sub-net mask numb
♦ IP address of the a
of the PC
address o tr nsmitter,
er,
g teway.
ACTIONS RESULT
To call up the
"INSTALLATION
PARAMETERS
Level 1" window
♦ Set switch SW1, situated in the
exciter/CPU interconnection card on the
side of the sub-units behind the CPU
card, such that the dot is visible.
♦ Reset the CPU Board
♦ The transmitter is switched to installation mode.
♦ The "INSTALLATION PARAMETERS Level 1"
window appears on the PCL and displays the
current transmitter configuration parameters.
To call up the
"ETHERNET
INSTALLATION
PARAMETERS"
window of the PCL
♦ Press "INSTALL NEXT" in the
"TRANSMITTER INTERFACE
INSTALLATION PARAMETERS",
"CABINET CONFIGURATION
PARAMETERS" and "INSTALLATION
ADAPT PARAMETERS" window.
♦ The "ETHERNET INSTALLATION
PARAMETERS" window appears on the PCL and
displays the current configuration parameters.
To insert a parameter
value
♦ Press on the control keys of the
parameter to be inserted,
♦ Enter the required value on the window
keyboard,
♦ Press "ENTER" to validate the entry
IMPORTANT :
• The network parameter must be
furnished by your network
administrator.
• Setting bad parameter disturbs the
network.
♦ The "NUMERICAL VALUE" window appears.
♦ The value is displayed under the window title.
♦ The "INSTALLATION PARAMETERS" window
appears. The value is displayed on the parameter
control keys.
Note:
♦ To cancel and entry press the "CANCEL"
key.
♦
The "INSTALLATION PARAMETERS"
window appears. The value remains
unchanged.
Calls up the
"INSTALLATION
PARAMETERS
Level 1" for validation
♦ Press "INSTALL NEXT" in the
"ETHERNET INSTALLATION
PARAMETERS" window.
♦ The "INSTALLATION PARAMETERS Level 1"
window appears on the PCL.
9932 V2
45321648.01 108 B E
Checked
19 / 192
Numéro / Number Doc. Rev. Lan
g
u.
27/06/2006
Pa
g
e